Spinner Rig
A step by step guide on how to tie a Spinner rig.
No crimps needed.
Difficulty: Easy.
What you will need:
A quality coated braid (PB Products Jelly Wire).
A constructed Ronnie Rig.
Snips.
Scissors.
A quality coated braid (PB Products Jelly Wire).
A constructed Ronnie Rig.
Snips.
Scissors.
Snip the ring off of the Ronnie.
You don't need this.
You don't need this.
Pass the coated braid through the swivel.
Form an loop knot.
Preferably a Figure 8 or No Slip loop knot.
(Overhand loop shown here)
Preferably a Figure 8 or No Slip loop knot.
(Overhand loop shown here)
Moisten the knot, and pull tight.
Trim off the tag end.
Trim off the tag end.
Tie a figure 8 loop knot in the tail end.
Try to get the loop around 1" / 25mm long.
TIP: To get the coated braid pin-straight, pass the hook link over the steam of a boiling kettle while pulling the rig tight.
Try to get the loop around 1" / 25mm long.
TIP: To get the coated braid pin-straight, pass the hook link over the steam of a boiling kettle while pulling the rig tight.
Add some tungsten putty over the loop as shown
to balance the pop-up bait to your liking.
to balance the pop-up bait to your liking.