Claw Rig
A step by step guide on how to tie a Claw Rig.
Use: Bottom bait. Wafter. Pop Up.
Difficulty: Medium.
What you will need:
Size 6 Korda Wide Gape.
Coated braid hook link.
Korda Kicker.
Tungsten putty.
Fine bore silicone tube.
Size 6 Korda Wide Gape.
Coated braid hook link.
Korda Kicker.
Tungsten putty.
Fine bore silicone tube.
Cut 12-14" hook link.
Remove 4-5" coating.
Tie an overhand loop.
Remove 4-5" coating.
Tie an overhand loop.
Cut 2 pieces of tubing 2-3mm.
Thread on to the hook link.
Thread on to the hook link.
Pass the hook, point first, through the tubing.
Position the tubing to set the hair length.
Tie a 5-6 turn knotless knot, moisten and pull tight.
Tie a 5-6 turn knotless knot, moisten and pull tight.
Cut 2-3mm off of the fat end of the kicker.
Thread the kicker on to the hook link.
Push on to the hook covering the top of the knotless knot.
Push on to the hook covering the top of the knotless knot.
Add tungsten putty to the hook link at the end of the coated section.
Tie a figure 8 loop knot, moisten and pull tight.
Tie a figure 8 loop knot, moisten and pull tight.